This FAQ has been written for NEAL (North East Africa and Levant) region. If you are looking for information for another region, please select the correct country from the top-left dropdown in the page and 'Navigate to Browse FAQs' in the Support menu.
Issue:
How to change the set points in an ACSC100 unit.
Product line:
ACSC100.
Environment:
All Serial Numbers.
Cause:
Install, Configure.
Resolution:
Press the <ESC> key until you get to the main menu On/Standby
Using the down arrow key scroll until you get to “Set Group Set Points”
Use the <ENTER> key
Enter Password Default=apc
Use the arrows to select character and then use the enter key to go to the next letter. After entering the correct password use enter again.
You can now select any set point and change the value.
How to change the set points in an ACSC100 unit.
Product line:
ACSC100.
Environment:
All Serial Numbers.
Cause:
Install, Configure.
Resolution:
Press the <ESC> key until you get to the main menu On/Standby
Using the down arrow key scroll until you get to “Set Group Set Points”
Use the <ENTER> key
Enter Password Default=apc
Use the arrows to select character and then use the enter key to go to the next letter. After entering the correct password use enter again.
You can now select any set point and change the value.
Released for:Schneider Electric Egypt and North East Africa
This FAQ has been written for NEAL (North East Africa and Levant) region. If you are looking for information for another region, please select the correct country from the top-left dropdown in the page and 'Navigate to Browse FAQs' in the Support menu.
Issue:
How to change the set points in an ACSC100 unit.
Product line:
ACSC100.
Environment:
All Serial Numbers.
Cause:
Install, Configure.
Resolution:
Press the <ESC> key until you get to the main menu On/Standby
Using the down arrow key scroll until you get to “Set Group Set Points”
Use the <ENTER> key
Enter Password Default=apc
Use the arrows to select character and then use the enter key to go to the next letter. After entering the correct password use enter again.
You can now select any set point and change the value.
How to change the set points in an ACSC100 unit.
Product line:
ACSC100.
Environment:
All Serial Numbers.
Cause:
Install, Configure.
Resolution:
Press the <ESC> key until you get to the main menu On/Standby
Using the down arrow key scroll until you get to “Set Group Set Points”
Use the <ENTER> key
Enter Password Default=apc
Use the arrows to select character and then use the enter key to go to the next letter. After entering the correct password use enter again.
You can now select any set point and change the value.
Released for:Schneider Electric Egypt and North East Africa
