EADM does not reflect PLC in NOCONF state when using EADM V3.1 or coming V3.2 to connect M340/PRA | Schneider Electric New Zealand

{}

0 item count of documents is

My Products Item count in basket is 0 My Documents Item count in basket is 0

How can we help you today?

EADM does not reflect PLC in NOCONF state when using EADM V3.1 or coming V3.2 to connect M340/PRA

Description:

When an M340 or BMXPRA PLC is in a "NOCONF" state and upon connecting via FTP or USB on EADM: --> the "Mode" section in Device List only shows "NOCONF" for a few seconds and then displays "STOP".

Expected/Normal behavior:

On Unity Loader, when M340 or PRA PLCs are NOCONF, the NOCONF state is displayed properly and does not get replaced by STOP after a few seconds.
On EADM, when an M580 PLC is NOCONF, the NOCONF state is displayed properly and does not get replaced by STOP after a few seconds.

Note:

The same behavior was observed on BMXPRA0100 (FW V3.51IR07) modules and on multiple FW versions of P34 2020:

V3.30IR10
V3.40IR08
V3.50IR08
V3.51IR07

This issue is planned to be fixed in EADM V3.3, Q2 2024.

Released for:Schneider Electric New Zealand

Published on:12/10/2023Last Modified on:12/10/2023

Range:

Modicon M340

Range:

Modicon M340