Release Notice
Connection issue between PL7 PRO with XIP driver to TSX MICRO connected on Ethernet with TSX ETZ 510
Goals and Symptoms
After a communication closure with TSX PREMIUM, then opening a new one with a TSX MICRO, without the closure of PL7 PRO, it is impossible to connect to the TSX MICRO.
Causes and Fixes
Solution 1: Close PL7, open again, define address of TSX MICRO, connection: OK
Solution 2: Without closure of PL7, create new PLC TSX MICRO, define address of PLC, connection: OK
Legacy KB System (APS) Data: RESL179251 V1.0, Originally authored by on , Last Edited by on
Related ranges: PL7
Released for:Schneider Electric UK
Did this answer your question?
Release Notice
Connection issue between PL7 PRO with XIP driver to TSX MICRO connected on Ethernet with TSX ETZ 510
Goals and Symptoms
After a communication closure with TSX PREMIUM, then opening a new one with a TSX MICRO, without the closure of PL7 PRO, it is impossible to connect to the TSX MICRO.
Causes and Fixes
Solution 1: Close PL7, open again, define address of TSX MICRO, connection: OK
Solution 2: Without closure of PL7, create new PLC TSX MICRO, define address of PLC, connection: OK
Legacy KB System (APS) Data: RESL179251 V1.0, Originally authored by on , Last Edited by on
Related ranges: PL7
Released for:Schneider Electric UK
Did this answer your question?
