• Open the DTM in the CE application.
• Click on Start Advantys to start tthe Advantys Configuration software and link it with the DTM..

• Right click on the STBNIC2212.
• Select 'Replace NIM'.

• Replace the STBNIC2212 V3 with the V4 module.

• Save the changes.
• Build the Advantys application.
• Save the changes.
• Set the rotary switches on the V4 module to the same position that was on the V3 module.
• Power cycle theSTBNIC2212.
• If the rotary switch is set to the 'Stored' position: (See below)
  • Open the web page for the STBNIC2212.
  • Assign the same IP address and
  • Leave the Device name blank in the web pages for the to the new STBNIC2212 .

• Power Cycle the STBNICC2212.
• Ensure that the Advantys island is in a ready state..
• Go back to CE.
• Apply the changes to the DTM.
• Rebuild.
• Save the changes.

• Connect to the M580 PLC.
• Transfer the CE application to the PLC.
• Connect to the STBNIC2212.

Released for:Schneider Electric UK