You are currently viewing the content available in Vietnam. If you are looking for information for another region, please select the correct country from the top-left dropdown in the page and 'Navigate to Browse FAQs' in the Support menu.
Issue:
Firmware for running drive over 599hz, but unable to run above 600hz.
Product Line:
Altivar 61 and 71
Environment:
All products of the Altivar 61 and 71 series
Cause:
Has the special software for running the drive over 599hz, but cannot get it to run above 600 hz.
Resolution:
The usual max is around 600 hz. To run above 600hz you will need to adjust some settings in the drive.
In Menu 1.4 Motor Control, set Rated Motor Frequency (FrS). Then define the maximum output frequency by setting the Max Frequency (tFr) and the High Speed (HSP) to appropriate values to increase the output frequency range.
Firmware for running drive over 599hz, but unable to run above 600hz.
Product Line:
Altivar 61 and 71
Environment:
All products of the Altivar 61 and 71 series
Cause:
Has the special software for running the drive over 599hz, but cannot get it to run above 600 hz.
Resolution:
The usual max is around 600 hz. To run above 600hz you will need to adjust some settings in the drive.
In Menu 1.4 Motor Control, set Rated Motor Frequency (FrS). Then define the maximum output frequency by setting the Max Frequency (tFr) and the High Speed (HSP) to appropriate values to increase the output frequency range.
Released for:Schneider Electric Vietnam
