You are currently viewing the content available in Vietnam. If you are looking for information for another region, please select the correct country from the top-left dropdown in the page and 'Navigate to Browse FAQs' in the Support menu.
Issue:
Overspeed Fault (SOF) on Process Drive
Product Line:
ATV600, ATV900
Environment:
Programming changes
Cause:
Programming change required
Resolution:
Need to program as follows or you will get Overspeed Fault and Measure very low voltage on the output of the drive, even at 60hz
How to run Process Drives with a Small or No Motor
1 - Set nPC (Motor Param Choice) to 'Mot Cosinus' [Main Menu] ->[Complete settings] -> [Motor parameters] -> [Motor data] -> [Data] -> [Motor Param Choice]
2 - Set Ctt [Motor Control Type] to 'U/F VC Quad' [Main Menu] -> [Complete settings] -> [Motor parameters] -> [Motor Control Type]
See overspeed faults attachment
3 - Set OPL to 'NO' [Main Menu] -> [Complete settings] -> [Error/Warning handling] -> [Output phase loss]
See Output Phase Loss Attachment
*See the applicable attached Programming Manual for further details.
Overspeed Fault (SOF) on Process Drive
Product Line:
ATV600, ATV900
Environment:
Programming changes
Cause:
Programming change required
Resolution:
Need to program as follows or you will get Overspeed Fault and Measure very low voltage on the output of the drive, even at 60hz
How to run Process Drives with a Small or No Motor
1 - Set nPC (Motor Param Choice) to 'Mot Cosinus' [Main Menu] ->[Complete settings] -> [Motor parameters] -> [Motor data] -> [Data] -> [Motor Param Choice]
2 - Set Ctt [Motor Control Type] to 'U/F VC Quad' [Main Menu] -> [Complete settings] -> [Motor parameters] -> [Motor Control Type]
See overspeed faults attachment
3 - Set OPL to 'NO' [Main Menu] -> [Complete settings] -> [Error/Warning handling] -> [Output phase loss]
See Output Phase Loss Attachment
*See the applicable attached Programming Manual for further details.
Released for:Schneider Electric Vietnam
